SawStop 10” Contractor Saw 57
Using Your Saw
Using an Out-Feed Table
You should use an out-feed table to support your work when cutting pieces longer than approximately 4
feet. The out-feed table attaches ush against the back edge of your saw and prevents your workpiece from
dropping off the back of your saw during cutting.
The SawStop
®
Out-Feed Table is designed specically for use with the T-Glide
TM
Fence System - Professional
Series (see Fig. 73). It does not attach to the SawStop
®
Contractor Fence Assembly.
You can learn more about the SawStop
®
Out-Feed Table from an authorized SawStop distributor or at
www.sawstop.com.
Fig. 73
Using Your Saw
To Next Page
Loading...
