SCADAmetrics EtherMeter - Description and Banner Setup Commands

47
SET DESCR1
TEXT DESCRIPTION FOR THE METER ATTACHED TO CHANNEL 1 (1 TO 4
CHARACTERS, NO SPACES).
1
SET DESCR2
TEXT DESCRIPTION FOR THE METER ATTACHED TO CHANNEL 2 (1 TO 4
CHARACTERS, NO SPACES).
2
SET BANNER
TEXT DESCRIPTION FOR THE ETHERMETER’S
LOCATION/PURPOSE/ETC... (1 TO 32 CHARACTERS).
NOTE 1: THE BANNER TEXT ENTERED SHOULD NOT CONTAIN ANY
SPACES. UNDERSCORES SHOULD BE ENTERED IN LIEU OF SPACES
WHEREVER NEEDED. THE ETHERMETER WILL AUTOMATICALLY
REPLACE THE UNDERSCORES WITH SPACES ON THE LCD DISPLAY,
WEB PAGE, AND SETUP MENU.
NOTE 2: TO CLEAR THE BANNER TEXT, TYPE: “SET BANNER<ENTER>”
<BLANK>
NOTE 1: THE UNIT EXECUTES A SOFT RESTART WHEN “REBOOT” IS ENTERED AT THE COMMAND
PROMPT.
NOTE 2: THE FACTORY DEFAULT SETTINGS ARE RESTORED WHEN “FACTORYRESET” IS ENTERED
AT THE COMMAND PROMPT.