Scaime eNod4-C - Target and Tolerances; Target Weight & Tolerances

74
SCAIME Manual : NU-eNod4C-E-0418-196712-F.docx
Target and tolerances
These functionnalities are only available in eNod4-C on versions >= 105
Target weight
0-1000000
The value to reach at the end of the checkweigher cycle
Tolerance -
Define the acceptable lower range for checkweigher results
Tolerance +
Define the acceptable upper range for checkweigher results
Stats only on in Tol
res
Option for only use checkweigher results within tolerances to calculate statistics
(results average, running total (results sum), standard deviation)