6
RETURN TO TABLE
OF CONTENTS
10.Unbolt and remove the wood block (7) located at the foot end base beneath
the wood skid.
11.Using an assistant, take hold of
each side of the table; then press
the
E
NABLE
/L
OCK
and
U
NLOCK
but-
tons and
hold for 3 seconds
. The
floor locks will disengage.
12.Carefully roll the table to the foot end of the skid. The skid tilts, allowing the
table to be rolled off.
13.Plug the table into a 115 VAC, 60 Hz, hospital grade, grounded outlet from 8
to 12 hours to fully recharge the batteries before actual use.
WARNING
The table w/ Pelvic Base (73001) weighs approximately 660
lbs. (299.4 kg). Get an assistant to help remove the table from
the shipping skid. Also, use proper lifting techniques when lifting table.
Failure to do so could result in serious back injury.
EQUIPMENT ALERT
Assure the brake cylinders have retracted all the way before at-
tempting to roll the table from the skid. Failure to comply may
cause damage to the brake cylinders.
EQUIPMENT ALERT
Use only 115 volt, alternating current (VAC), 60 cycle (Hz) to oper-
ate or recharge the batteries in the table. Failure to comply could
result in damage to the table.
EQUIPMENT ALERT
To prevent damage to the table, allow the table to reach room tem-
perature before operating. This is especially important when the
table has been exposed to below freezing temperature during transit.
ENABLE
LOCK
UNLOCK
Installation
To Next Page
Loading...