P746/EN ST/G31 Settings
(ST) 4-
26
MiCOM P746
ST
Setting Range
Menu Text Default Setting
Min. Max.
Step Size
Fn. Key 1 Label Function Key 1
Allows the text of the function key to be changed to something more suitable for the
application.
Fn. Key 2 to 10
Status
Unlocked Disabled, Locked, Unlock
Setting to activate function key. The ‘Lock’ setting allows a function key output that is set to
toggle mode to be locked in its current active position.
Fn. Key 2 to 10 Mode Toggled Toggled, Normal
Sets the function key in toggle or normal mode. In ‘Toggle’ mode, a single key press will
set/latch the function key output as ‘high’ or ‘low’ in programmable scheme logic. This
feature can be used to enable/disable relay functions. In the ‘Normal’ mode the function
key output will remain ‘high’ as long as key is pressed.
Fn. Key 2 to 10 Label Function Key 2 to 10
Allows the text of the function key to be changed to something more suitable for the
application.
1.3.11 “IED Configurator” column
The contents of the IED CONFIGURATOR column (for IEC 61850 configuration) are mostly
data cells, displayed for information but not editable. In order to edit the configuration, it is
necessary to use the IED (Intelligent Electronic Device) configurator tool within MiCOM S1.
Setting Range
Menu Text Default Setting
Min. Max.
Step Size
IED CONFIGURATOR
Switch Conf.Bank No Action No Action, Switch Banks
Setting which allows the user to switch between the current configuration, held in the
Active Memory Bank (and partly displayed below), to the configuration sent to and held in
the Inactive Memory Bank.
Restore MCL No action No action / Restore MCL
Used to restore data from MCL binary file. MCL (MiCOM Configuration Language) files are
specific, containing a single devices IEC61850 configuration information, and used for
transferring data to/from the MiCOM IED.
Active Conf.Name Data
The name of the configuration in the Active Memory Bank, usually taken from the SCL file.
Active Conf.Rev Data
Configuration Revision number of the Active Memory Bank, used for version management.
Inact.Conf.Name Data
The name of the configuration in the Inactive Memory Bank, usually taken from the SCL
file.
Inact.Conf.Rev Data
Configuration Revision number of the Inactive Memory Bank, used for version
management.
To Next Page