Getting Started P746/EN GS/G31
(GS) 3-
34
MiCOM P746
CT AND VT RATIOS
Restore Defaults Main VT Primary Clear Events Duration Default Display *
No Operation 110,0 V No 1.500 ms Description
Setting Group Main VT Sec'y Clear Faults Trigger Position Local Values
Select via Menu 110,0 V No 33,30 % Primary
ctive Settings Tx CT * Clear Maint Trigger Mode Remote Values
Group 1 No Single Primary
Save Changes Polarity
larm Event
nalog Channel 1 * Measurement Ref
No Operation Standard Enabled
AN
Copy From Primary Relay O/P Event
nalog Channel 2 * Measurement Mode
Group 1 1.000 kA Enabled
BN 0
Copy To Secondary Opto Input Event * front panel user
No Operation 1000
Enabled interface only
* x = 1 to 6 (1 box)
Setting Group 1 x = 1 to 18 (3 box) General Event
nalog Channel 20 *
Enabled Enabled IB-T6 / IX-T17
Setting Group 2 Fault Rec Event
nalog Channel 21 *
Disabled Enabled IC-T6 / IX-T18
Setting Group 3 Maint Rec Event Digital input 1 *
Disabled Enabled Output R1
Setting Group 4 Protection Event Input 1 Trigger *
Disabled Enabled No Trigger
OP Mode Clear Dist Recs Digital Input 2 *
One Box Mode No Output R2
Diff Protection DDB 31 - 0 Input 2 Trigger *
Enabled 111111111111111 No Trigger
Dead Zone OC DDB 63 - 32
Disabled 111111111111111
Overcurrent DDB 95 - 64 Digital Input 32 *
Enabled 111111111111111 Function key 10
Earth fault Input 32 Trigger *
Enabled Trigger L/H
CB fail Setting Values DDB 2015 - 1984
Disabled Primary 111111111111111 * see section P746/EN T
for the default settings.
Supervision Control Inputs DDB 2047 - 2016
Disabled
isible 111111111111111
Input Labels Control I/P Config
isible
isible
Output Labels Control I/P Labels
isible
isible
CT & VT Ratios Direct Access
isible Enabled
Record Control Function Key
isible
isible
Disturb Recorder RP1 Read Only
isible Disabled
Measure't Setup RP2 Read Only
isible Disabled
Comms Setting NIC Read Only
isible Disabled
MEASURE'T SETUP
(When Visible)
CONFIGURATION
RECORD CONTROL
(When Visible)
DISTURB RECORDER
(When Visible)
GS
Commission Tests LCD Contrast
isible 11