Schenker MODULAR 150 Installation, Use & Maintenance Manual

4 – MOUNTING AND INSTALLATION COD.150M230.T.2021
EN
THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
24
4.4 Hydraulic connections
HYDRAULIC CONNECTION AND HOSES
FIG. 4-1
Pressurized fresh water valve
Pump group
Elecrovalve
Non return valve
5 micron filter
Mesh filter
Swan neck upward - Discharge
Water inlet
Watermaker
Active carbon filter
Fresh water outlet
The hydraulic section that is continuously under consistent pressure is the pump outlet – 5 m. filter –
watermaker inlet connections . For this section is necessary to use a good quality PN 20 min. reinforced
hose. An inadequate hose could burst, jeopardizing seriously the safety of the vessel.
Plumb to
pressure
side of
vessel
fresh water
system
Exhausted
discharge
“Armorvin”
type hose
int. dia. 20
mm.
Reinforced hose
PN20 min int. dia.
20 mm.
“Armorvin”
type hose
int. dia. 16 mm.

Schenker MODULAR 150 Specifications

General

Brand	Schenker
Model	MODULAR 150
Category	Water Filtration Systems
Language	English