Schenker MODULAR 150 Installation, Use & Maintenance Manual

5 – FUNCTIONING AND USE COD.150M230.T.2021
EN
THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
31
5. FUNCTIONING AND USE
5.1 Command description
HOME PAGE – PAGE 1
FIG. 5.1
N°
Fuction
Possible options
1
Remote panel voltage
12 / 24 V
2
Pump status
ON / OFF
3
Info box
System status / Alarms
4
Salinity control (optional)
OK / MED / BAD /WAIT
5
Flow rate (optional)
Fresh water lit/hour
6
Timer
Working hours / total hours / total liters
The touch screen remote panel has 3 pages. The display switches off after 3 minutes of not use. Touching in
any point will light the display up again, without activate any other command.
In the home screen it is possible to check the status of the watermaker and perform the following functions:
START
Used to start the system; the unit runs indefinitely until STOP is pushed.
STOP
Used to stop the system. The system doesn’t stop immediately but awaits the correct positioning of the internal
valve (2-3 seconds), and then stops. If the automatic washing is activated the system performs the automatic
washing (1 min) before stopping.
STOP is used as well for an emergency stop, by pressing it for 5 seconds: in this case the watermaker stops
immediately.
FLUSH
The system gets ready to perform an automatic washing (1 minute long) once the system is stopped.

Schenker MODULAR 150 Specifications

General

Brand	Schenker
Model	MODULAR 150
Category	Water Filtration Systems
Language	English