www.scheppach.com
32
|
GB
3. Fill the fuel tank (9) with fuel up to max. 3-4 cm
below the top edge.
4. Replace the fuel tank cover (8) and close the fuel
10.3 Connecting the water supply (external) to
the pump (Fig. 12)
m WARNING
• If the inlet sieve is missing or damaged, do not
operate the high-pressure cleaner. Particles in the
ATTENTION
• The length of the free garden hose must be at least
3m between the inlet of the high-pressure cleaner
• Do not operate the high-pressure cleaner without a
If the high-pressure cleaner is operat-
ed without water, the high-pressure cleaner will be
damaged.
1. Before connecting the garden hose (NOT includ-
check the inlet sieve. Clean a contaminated inlet
sieve, replace a damaged inlet sieve (40, Fig. 2).
2. To remove all impurities, run water through the
garden hose for 30 seconds.
Important: Do not suction stagnant water for the
3. Fit the hose connection adapter (38) on the water
inlet (29).
4. The garden hose (NOT included in the scope of
connector (37).
5. Connect the garden hose (NOT included in the
The hose
must not be longer than 15 m.
6.
10.4 Self-suction from open tanks/containers and
natural bodies of water
m DANGER
• Never suck up water from a drinking water tank.
• Never suck up liquids containing solvents such as
paint thinner, petrol or oil.
Use the self-priming accessories (not included in
•
• 3 m reinforced vacuum hose
max. 0.5 m above the water level. This can last about
1 minute.
1. -
der water to displace the air.
• Too loose a con-
1.
gun (23).
2.
3.
gun (23).
4. Attach the high-pressure hose (2) to the water
10. Before commissioning
m Attention!
Always make sure the product is fully assembled
before commissioning!
10.1 Filling/checking the engine oil (Fig.10)
ATTENTION
•
• Check the oil level before each start-up.
• Do not operate the device if no oil is visible on the
oil dipstick (12.1).
• Too high an oil level
can lead to engine damage.
•
(SAE10W30).
1. -
dipstick (12)/oil tank cover with oil dipstick (12.1).
2. Open and remove the oil tank cover with oil dip-
3. -
gine oil (SAE10W30) as required.
4. Check the oil level using the marks on the oil dip-
stick.
5. Place on the oil tank cover with oil dipstick (12.1)
10.2 Filling in fuel (Fig. 11)
m DANGER
Risk of re and explosion!
•
bioethanol component.
• Never refuel the device in enclosed spaces, with the
engine running or hot.
• Do not smoke when refuelling.
• Do not use a two-stroke mixture.
•
• Do not spill fuel. Use funnel.
• Wipe up spilled fuel.
•
1. -
ing anti-clockwise.
2. Place a funnel (36) in the opening of the fuel tank (9)
To Next Page
Loading...
