EasyManua.ls Logo

Scheppach HCP5000 - Cleaning; Maintenance; Transport

Scheppach HCP5000
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.scheppach.com
GB
|
35
Keep protective devices, air vents and the engine
housing as free of dust and dirt as possible. Rub
󰀨
compressed air at low pressure.


Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use chemical
cleaning agents or solvents. These could damage
the plastic parts of the device. Make sure that no
water penetrates the device interior.
13.1 Nozzle cleaning
If there is a pulsating sensation when the trigger
  

1. 󰀨

2. Depressurise the device (see 11.6).
3.        
(17).        

4. Use the nozzle cleaner needle (34) or a small pa-
per clip to remove debris from the nozzle (3).
5. Rinse the nozzle (3) with clear water.
6. 
7. 
13.2 Draining water
ATTENTION
Risk of damage!
        
the device.
In winter, store the device preferably in a heated
room.
When storing in an unheated room, proceed as
follows:
1.       -
sure hose (2).
2. Let the device run for max. 1 minute until the

14. Maintenance
m WARNING
󰀨-
ting or maintenance work.
Remove the spark plug connector (31).
m DANGER

device.
Before working on the device, turn the engine switch
󰀨
Danger of burning

12. Transport
m CAUTION

Note the weight of the device during transport.
12.1 Preparation for transport
Note:
-
ner!
1. 

2. To ensure that no petrol remains in the carburet-
tor, the remaining petrol in the carburettor must be
drained out. To do this, place a suitable container

carburettor and open the petrol drain screw (41).
Fig.16:
3. Drain the engine oil from the warm engine (as de-
scribed).
4. Remove the spark plug connector (31) from the
spark plug.
5. Wind up the high-pressure hose (2) and place it in
the hose holder (27).
6.       

the transport holder (4).
7. 
8. When transporting the device in vehicles, secure
-
ample with tension straps, in accordance with the
applicable directives.
13. Cleaning
m DANGER

device.
Before working on the device, turn the engine
󰀨   -
nector.
Danger of burning

m WARNING
󰀨-
ting or maintenance work.
Remove the spark plug connector (31).
ATTENTION
󰀨
customer service:
- In the event of unusual vibrations or noises.
- 

Table of Contents

Related product manuals