www.scheppach.com
34
|
GB
11.5.1 Recommended cleaning method
1.
and leave to act for 1 - 5 minutes, but do not allow
2.
11.5.2 After operation with cleaning agent
1. After operating with cleaning agent, clean the
cleaning agent tank (15) and the connected hos-
es.
ATTENTION
Do not leave the cleaning agent in the cleaning agent
tank (15)!
•
To clean the cleaning agent tank (15) and the
high-pressure pump (30), proceed as follows:
1.
2. Fill the cleaning agent tank (15) with clear water.
3. Insert the cleaning agent nozzle (3) (black) on the
4. Start up the high-pressure cleaner as described
in chapter 10.
5. Rinse the high-pressure cleaner with clear water
for several minutes.
11.6 Interrupting operation
•
Note:
released, the engine continues to idle.
1.
(several minutes) (see 11.2).
2. Pull the trigger (25) until the device is depressur-
ised.
3.
lock (24) against unintentional opening.
11.7 Finishing work
1.
2.
cleaner.
3. Pull the trigger (25) until the device is depressur-
ised.
4.
lock (24) against unintentional opening.
5.
3. Pull the ring back, insert the selected nozzle (3)
and release the ring. Pull on the nozzle (3) to
4. The best cleaning results are achieved when the
nozzle (3) is held at a distance of 20 to 60 cm from
the surface to be cleaned. If the distance is too
5.
at least 30 cm.
11.5 Operation with cleaning agents
m WARNING
1. -
ting or maintenance work.
ATTENTION
Unsuitable cleaning agents can damage the device
•
suitable for high-pressure cleaners. This device is
intended for use with cleaning agents recommend-
•
agents that are suitable for use with high-pressure
cleaners. These are available in DIY and car ac-
cessories stores, among others.
ATTENTION
Cleaning agents can be harmful to the environment.
• Observe the manufacturer‘s instructions when us-
ing and disposing of the cleaning agent and waste
water.
Proceed as follows to work with cleaning agents:
1. Prepare the cleaning agent solution according to
the manufacturer‘s instructions.
2. Read the instructions for using the nozzles (3)
(see 11.4.1).
3. Check that the nozzle (3) for cleaning agent
(black) has been inserted.
4.
(16).
5. Fill the cleaning agent tank (15) with cleaning agent.
ATTENTION
• Cleaning agent must not be applied with the
high-pressure nozzles (3) (white, green or red).
1. Check that the garden hose is also connected to
the water inlet (29) (see 10.3).
2. Check whether the high-pressure hose (2) is con-
-
let (28) (see 9.7).
3. Insert nozzle (3) for cleaning agent (black) on
4. Then start the engine (see 11.1).
To Next Page
Loading...
