www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
30
|
GB
11.
full the technical requirements of this power tool
12.
sawing wood and never for working metal.
13. Use the saw blade intended for the material to be
processed.
14. -
15.
equal or higher rotational speed than that marked
on the power tool.
16. -
facturer which conform to EN 847-1, if intended for
cutting wood or similar materials.
17. Wear suitable personal protective equipment,
such as:
– hearing protection;
– protective gloves when handling saw blades.
18. -
facturer which conform to EN 847-1. Warning! When
changing the saw blade, make sure that the cutting
width is not smaller and the thickness of the saw
blade is not greater than the thickness of the splitter.
19. When sawing wood and plastics, avoid overheat-
ing the saw teeth. Reduce the feed speed to avoid
the plastic melting.
Residual Risks
This power tool has been constructed in accord-
ance with the latest technology and the generally
recognised safety regulations. Nevertheless, it is
possible that individual residual risks may occur
during operation.
• Electrical hazard if improper electrical connection
cables are used.
•
in spite of all the precautions that have been taken.
•
the designated purpose“, as well as the operating
instructions.
• -
-
tion in the performance of the machine, as well as a
•
inserting the plug into the socket, the power button
must not be pressed.
• Use the tool which is recommended in this manual.
•
the machine is in operation.
•
e) Secure the circular table saw.
can move or topple.
f) Remove the adjustment tools, wood residues,
etc. from the circular table saw before switch-
ing it on.
g) Always use the right size of saw blade
and an appropriate location hole (e.g. dia-
mond-shaped or round).
of the saw will run out-of-centre and result in a loss
of control.
h) Never use damaged or incorrect saw blade
mounting materials, such as anges, washers,
screws or nuts.
These saw blade mounting materials have been
-
i) Never stand on the circular table saw and do
not use it as a step stool.
Serious injuries can arise if the electric tool topples
saw blade.
j) Make sure that the saw blade is mounted in the
correct direction of rotation. Do not use grinding
discs or wire brushes with the circular table saw.
of accessories that have not been recommended
can result in serious injuries.
Safety instructions for handling saw blades
1.
2. -
imum speed stated on the tool being used must
not be exceeded. Keep within the speed range if
3. Note the direction of rotation of the motor and saw
blade.
4.
cracked insertion tools. Repairs are not permitted.
5.
surfaces.
6.
reduce holes on circular saw blades.
7.
insertion tool have the same diameter and have at
least 1/3 of the cutting diameter.
8.
each other.
9. Handle the tools used with care. It is best to store
these in their original packaging or special con-
10. -
To Next Page
Loading...
Need help?
General
