www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
36
|
GB
14.2 Faulty electrical connection cable
Insulation damage often occurs to electrical connec-
tion cables.
• Pressure points if connection cables are routed
through windows or door gaps.
•
the connection cable.
•
connection cable.
•
socket.
• Cracks resulting from the insulation becoming old.
Electrical connection cables should be checked reg-
the connection cable is not connected to the mains.
-
tion cables with the marking.
-
ble must be printed on it.
-
14.3 Alternating current motor
• The mains voltage must be 230 V~.
• Extension cables up to 25 m in length must have a
cross-section of 1.5 mm².
Connections and repairs to the electrical equipment
information:
•
•
•
15. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit.
The raw materials in this packaging can be reused
-
-
ponents must be disposed of as special waste. Ask
3. Installation of the new table insert (5) takes place
in reverse order.
12.3 Carbon brushes
If excessive sparks are generated, have an electri-
cian check the carbon brushes. Attention! The car-
12.4 Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Carbon brush, saw blade, table inserts,
push stick
13. Storage
frost-proof place that is inaccessible to children. The
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.
14. Electrical connection
The installed electric motor is connected ready
for operation. The connection complies with the
relevant VDE and DIN regulations. The custom-
er‘s network connection and any extension cable
used must comply with these regulations.
• The product meets the requirements of EN 61000-
3-11 and is subject to special connection condi-
connection points is not permitted.
• If the network conditions are unfavourable, the de-
•
which
-
pedance `Z; or
-
• -
product meets one of the two mentioned require-
ments a) or b).
14.1 Important Instructions
-
can be switched on again.
To Next Page
Loading...
