www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
31
In doing so, take into account the complete working
process, including the times when the electric tool is
-
ures include regular maintenance and care of the
electric tool and the insertion tools, regular breaks as
well as proper planning of the working process.
7. Before putting into operation
•
• Remove the packaging material as well as the
packaging and transport bracing (if available).
•
•
port damage.
•
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, lm and small parts! There is a risk of
swallowing and suocation!
•
down on a workbench, base frame or similar.
• Before the machine is put into operation, all covers
•
•
with, check for foreign bodies such as nails or
screws etc.
•
parts are free-running.
• Before connecting the machine, check that the data
•
of at least 16A.
8. Assembly
m Warning! Risk of injury!
-
-
stall the circular table saw, including all covers and
Never plug the mains plug into the power outlet be-
fore completing the installation.
If connections are secured with a hexagon screw, nut,
spring washer and washer, the washer and spring
-
agon screw or nut.
6. Technical data
AC motor 230 V~ 50Hz
Power 2000 Watt
Operating mode S1 & S6 40% *
Idling speed 4800 min
-1
Carbide saw blade ø 254 x ø 30 x 2,8 mm
Number of teeth 24
Thickness riving knive 2,5 mm
Min. workpiece size
W x L x H 10 x 50 x 1 mm
Table size 546 x 630 mm
Cutting height max. 90° 87 mm
Cutting height max. 45° 55 mm
Height adjustment 0 - 87 mm
Saw blade, swivelling 0 - 45°
Extraction connection ø 40 mm
Weight ca. 21/22 kg
* Operating mode S6 40%: Continuous operation with
stated nominal power and must then continue run-
Noise emission values
Sound values were measured in accordance with EN
62841.
Sound pressure level L
pA
93,5 dB(A)
pA
3 dB
Sound power level L
WA
106,5 dB(A)
WA
3 dB
Wear hearing protection.
vibration values (vector sum of three directions) de-
termined according to EN 62841.
NOTE:
been measured in accordance with a standardised
test procedure and can be used for comparison of
one electric tool with another.
used for an initial estimation of the load.
m WARNING:
in which the electric tool is used, and in particular
Implement
measures to protect against noise nuisance.
To Next Page
Loading...
Need help?
General
