www.scheppach.com
36
|
GB
22. Extraction port
23. Hose clamp for extraction hose
24. Machine stand
25a. Machine stand part 1
25b. Machine stand, part 2
25c. Machine stand, part 3
25d. Machine stand, part 4
25e. Machine stand, part 5
25f. Machine stand, part 6
26. Ring spanner, 10 / 13 mm
27. Ring spanner 10 / 21 mm
28. Groove
29. Sight glass
30. Wooden push block (not included in the scope
of delivery)
4. Scope of delivery
• Operating manual
• Saw blade
• Saw blade guard
• Parallel stop
• Guide rail for parallel stop
• Transverse stop
• Guide rail for transverse stop
• Clamping handle for transverse stop
• Push stick
• Hose clamp for extraction hose
• Machine stand part 1
• Machine stand, part 2
• Machine stand, part 3
• Machine stand, part 4
• Machine stand, part 5
• Machine stand, part 6
• Ring spanner, 10 / 13 mm
• Ring spanner 10 / 21 mm
Assembly material
A. M8 x 78 mm coach bolt (8x)
B. Allen screw M6 x 53 mm (4x)
C. M5 x 50 mm Phillips screw (2x)
D. M5 x 40 mm Phillips screw (4x)
E. M6 x 55 mm coach bolt (2x)
F. M5 x 10 mm Phillips screw (1x)
G. Knurled nut (2x)
H. Small washer (2x)
I. Large washer (4x)
J. Spacer (8x)
K. Nut M8 (8x)
L. M6 nut (4x)
M. M5 nut (7x)
N. Flat end cap (6x)
O. Round end cap (2x)
P. Wheel screw (2x)
5. Proper use
The circular table saw is used for the longitudinal and
transverse cutting (only with the transverse stop) of
all types of timbers and plastic, in accordance with
the machine size. It is not permitted to cut any type
of round timber.
Only suitable saw blades (HM or CV saw blades) may
be used for the machine. The use of HSS saw blades
and any type of cutting wheels is prohibited.
Notes:
Compliance with the regulations, safety instructions,
descriptions and notes in this operating manual are
part of proper use.
of the manufacturer, as well as the dimensions speci-
Working on or with the product may only be carried out
as described in this operating manual. All other main-
tenance and repair work not described in this operat-
ing manual must be carried out by a customer service
centre.
Please observe that our equipment was not designed
with the intention of use for commercial or industrial
purposes. We assume no guarantee if the equipment
is used in commercial or industrial applications, or for
equivalent work.
Other general occupational health and safety-related
rules and regulations must be observed.
m ATTENTION
When using the product, several safety warnings must
be observed to prevent injuries and damage. For this
reason, carefully read the operating and safety instruc-
tions. Keep them in a safe place so that the information
is available at all times. If the product is handed over
to another person, hand over the operating and safety
instructions with it.
We accept no liability for accidents or damage that oc-
cur due to a failure to observe this operating manual
and the safety instructions.
The liability of the manufacturer and resulting dam-
machine.
To Next Page
Loading...
Need help?
General
