www.scheppach.com
GB
|
53
19. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Saw blade is loose after
Fixing nut not tight enough
Motor does not start Mains fuse blown Check mains fuse
Extension cable defective Replace the extension cable
Connection to the motor or
switch not OK
Have this checked by an electrician
Motor or switch faulty Have this checked by an electrician
Motor not supplying power,
fuse tripping
Cross section of the
see “Electrical connection”
Overload due to blunt saw
blade
Replacing the saw blade
Burnt areas on the cutting
surface
Blunt saw blade Have an authorised sharpening service
sharpen the saw blade or replace it
Incorrect saw blade Replace saw blade
Incorrect motor rotational
direction
Direction of rotation
Capacitor defective Have this checked by an electrician
Incorrect connection Have an electrician transpose the wall plug
poles
To Next Page
Loading...
Need help?
General
