Schindler 3100/3300/6300 J 43402603 / 01 103/269
Copyright © 2017 INVENTIO AG
0074
ELEVATOR TRACTION MEANS TEMP EXCEEDED
The temperature of the elevator traction means (for example, belts) has
exceeded the allowable operating temperature
C1:Too hot ambient air temperature (temperature in hoistway)
A1:Wait for cool down
C2:The temperature feedback signal (for example, KTHS) is faulty
A2:Check general wiring to temperature sensor
C3:The heat dissipation is not working
A3:Check operation of heat dissipation device (for example, fan or forced
ventilation) if present
0076
ELEVATOR CAR LIGHT BROKEN
The car light has broken. Recognized by the alarm button backlight which is
switched on continuously.
C1:The car light is broken.
A1:Replace car light and verify that the COP alarm button backlight,
when available, is properly switched off
C2:The car light sensor on COP is defective
A2:Check car light sensor on COP for proper working. Illuminating the
sensor should switch the alarm button backlight off, covering the sensor
should switch the alarm button backlight on.
C3:A light absorbing or dark car interior cladding has been installed after
commissioning and the available light is not enough to activate the
sensor.
A3:If the car light condition is OK perform again a learning trip to check
and store the new working condition of the sensor. (if light is not enough
the error 0077 might be reported)
0077
ELEVATOR NO CAR LIGHT SENSOR
Car light sensor not detected
C1:During learning trip the COP car light sensor is reporting erratic
values or is reporting light switched off.
A1:Check proper working of car light. Check that the backlight of the
COP alarm button lights up when light sensor covered and switches off
when light sensor illuminated. If light is considered to be working
correctly ignore the error (the car light monitoring will remain disabled-
no error 0076 will ever be generated)
0078
ELEVATOR CAR LIGHT OK
Whenever the controller notices that the car light is broken, it sends an
ELEVATOR CAR LIGHT BROKEN event. Once the light is working again, it
signals it with an ELEVATOR CAR LIGHT OK event.
C1:
A1:No action required
0079
ELEVATOR CAR BLOCKED *)
The car was blocked in down direction.
A1:Elevator recovers automatically from this error by user (or recall)
traveling in up-direction
0080 ELEVATOR CAR EMERGENCY EXIT MISUSE DETECTED
The controller detects a misuse of the emergency exit trap.
Code General Message
To Next Page
Loading...