Schlage Artus - Handing (as required); Adjust spindle holder direction; Position external unit to the door

3. Handing (as required) 5. Attach gaskets
2 3
Insert hex key into the
spindle hole, remove
screw to loosen the
lever. Rotate the lever
180° and tighten the
screw to reattach the
lever. Repeat for the
internal unit.
Attach and secure rubber
gaskets to the internal and
external units.
A. Insert spindle into
the hub.
B. Ensure the spindle
holder arrow points
in the direction of
the lever.
Position the external
unit to sit ush on
the door, ensuring
the cable and
spindle go through
the xing holes.
Adjust the top xing
post to align with
the top xing hole.
4. Adjust spindle holder direction 6. Position external unit to the door
Arrow
B.
A.