SC1M
17
English
6.2 Speed Dialing
1. Press and hold the (+) Button for 3 seconds and you will hear a mid-
tone single beep and a voice prompt, “Speed dial”.
2. Tap the (+) Button or the (-) Button to navigate between the menus.
You will hear prompts for each menu item.
3. Tap the Center Button to select a voice menu among the followings:
(1) Last number redial (4) Speed dial 3
(2) Speed dial 1 (5) Cancel
(3) Speed dial 2
4. After selecting the last number redial menu, “Last number redial”.
Then, to redial the last phone call number, tap the Center Button.
5. To call one of the speed dials, tap the (+) Button or the (-) Button to
navigate between the menus until you hear a voice prompt, “Speed
dial (#)”. Then, tap the Center Button.
6. If you want to exit the speed dial immediately, tap the (+) Button or
the (-) Button until you hear a voice prompt, “Cancel”, and tap the
Center Button.
6.3 GPS Navigation
6.3.1 GPS Pairing
1. To enter the conguration menu, press and hold the Center Button for
10 seconds until you hear the voice prompt, “Conguration menu”.
2. Tap the (+) Button until you hear a voice prompt, “GPS pairing”.
3. Search for Bluetooth devices on the GPS navigation. Select the SC1M
in the list of the devices detected on the GPS.
4. Enter 0000 for the PIN.
Note:
When Audio Multitasking is enabled, if you pair your GPS device via GPS Pairing, its
instructions will not interrupt your intercom conversations, but will overlay with them.
6.4 Sena SR10, Two-Way Radio Adapter
You can use a two-way radio and the SC1M Bluetooth intercom
simultaneously by using the Sena SR10, a Bluetooth Two-way Radio
Adapter (please refer to
section 5.2, “Second Mobile Phone Pairing -
Second Mobile Phone, GPS, and SR10”
). Incoming audio from the two-
way radio will not interrupt an intercom conversation but is heard in the
background. This is useful when you have an intercom conversation
with a passenger on the back seat and use a two-way radio for group
communication with other motorcycle riders.