BEFORE USING YOUR NEW MACHINE
1. When towing a new machine, stop and feel the wheel hubs after 6-10 miles. If hub is hot to
the hand, remove hub cap and back spindle nut off 1/4 – 1/2 turn.
2. Check for proper assembly and adjustments. Make sure all lift flight bolts, floor flight bolts,
hitch bolts, wheel bolts, sprocket and pulley set screws, etc. are tightened securely. After a few
days of use, check and re-tighten all sprockets, bearings and pulley set screws. PROTECT
YOUR INVESTMENT!!
3. Check tires and inflate to the recommended pressure.
4. Adjust the tractor drawbar as described on Page 8.
5. Have all shields in place. DO NOT OPEN SHIELDS WHILE THE MACHINE IS RUNNING OR
OPERATE MACHINE WITH SHIELDS REMOVED.
6. Before loading, operate machine very slowly for a short time. On first few loads, operate
machine slowly so chains can work in and can determine that all parts work freely.
DO NOT ADD ANY SIDE BOARDS TO YOUR MIXER/FEEDER OTHER THAN WHAT IS
FURNISHED BY THE FACTORY.
Recommended Tire Pressures
295/75R 22.5 -- 75PSI
385/65R 22.5 -- 75PSI
-7-
To Next Page
Loading...