Schuler HF255 - Safety and Operational Decals

- 2 -
SAFETY AND OPERATIONAL DECALS
SAFETY AND OPERATIONAL DECALS
SAFETY DECALS ARE PLACED ON THE MIXER/FEEDER FOR THE PROTECTION OF THE
OPERATOR OR ANY PERSON NEAR THE UNIT.
Be sure everyone who operates this equipment understands all the information, warning, caution, and
danger decals.
Keep the decals CLEAN so they are readable. This applies to all caution, warning, and danger decals.
It is the OWNER’S RESPONSIBILITY to provide information for safe operation of this machine.
Replace any damaged or worn decals. Once any part of a decal becomes non-readable, it should be
replaced. The part numbers for the decals are located in the lower RH corner of the decal, and listed in
this manual on the following pages. Replacement decals may be ordered through your dealer or the
address below.
When replacing decals, be sure the surface area is clean and dry, peel the backing off the decal, and
apply to the machine. Be sure to wipe with a clean cloth to rub out all air bubbles to assure a good
seal. For best adhesion, decals should be applied in temperatures of 50 degrees (F) or warmer.
DECALS
ITEM
QTY
PART NUMBER
DESCRIPTION
1
1
10010-0210
DECAL, DANGER, PTO, ROTATING DRIVE LINE
2
3
10010-0220
DECAL, DANGER, IF YOU CAN READ THIS, THE SHIELD IS NOT IN...
3
1
10010-0225
DECAL, DANGER, DO NOT USE THIS SHIELD FOR STEP
4
4
10010-0310
DECAL, WARNING, KEEP AWAY MOVING PARTS... (ARM IN RC)
5
5
10010-0317
DECAL, WARNING, KEEP OUT MOVING PARTS, FAILURE TO HEED...
6
1
10010-0421
DECAL, IMPORTANT, READ OPERATORS MANUAL, OPERATOR
7
1
10010-0500
DECAL, SLOW MOVING VEHICLE
8
3
10010-0920
DECAL, RED REFLECTIVE TAPE, 2 * 9 (REFLEXITE)
9
2
10010-0921
DECAL, YELLOW REFLECTIVE TAPE, 2 * 9 (REFLEXITE)
10
2
10010-0323
DECAL, WARNING, ROTATING PARTS, DISENGAGE POWER
6
10010-0522
DECAL, GREASE GUN, 50 HOURS
1
10010-0610
DECAL, IMPORTANT, USE 300-400 PTO RPM, MACHINE MUST BE...
1
10010-0611
DECAL, IMPORTANT, MANUAL INSIDE SHIELD
1
10010-0615
DECAL, IMPORTANT, DO NOT OPERATE MACHINE W/CONVEYOR...
1
10010-0631
DECAL, IMPORTANT, TIGHTEN FLOOR CONVEYOR SO TIGHTENER..
1
10010-0661
DECAL, IMPORTANT, A SPECIAL SHEAR KEY FOR FLOOR APRON
1
10010-0664
DECAL, IMPORTANT, TIGHTEN WHEEL LUGS
1
10010-0730
DECAL, FLOOR SPEEDS, FOR RATCHET DRIVE UNITS
1
10010-0750
DECAL, MANUAL BRACKET SERIAL NO. IF MANUAL IS MISSING...
1
10010-0100
DECAL, SCHULER, QUALITY BUILT, TDC
3
10010-0101
DECAL, SCHULER, 4 * 20, TDC
1
10010-0161
DECAL, MODEL, 'HF255', TDC
1
10010-0163
DECAL, MODEL, 'HF295', TDC