LOADING
In winter weather before loading, be sure the floor apron and elevator are not frozen to the
floor.
BEGIN LOADING THE MIXER/FEEDER AT THE FRONT END AND WORK TOWARD THE BACK.
When unloading, to avoid damage to the PTO drive parts, the PTO shaft must be kept straight.
For best mixing action, load each ingredient in a layer across the length of the box. Generally
the more coarse materials should be loaded first on the bottom with finer materials on top.
ATTENTION FOR UNITS WITH ELECTRONIC SCALES
Always remove the scale indicator box before welding on the equipment. Be sure, if necessary
to weld, the welding current does not pass through a weigh bar. Ground to the item being
welded. If on a truck mounted unit, disconnect the battery and alternator before welding.
-10-
To Next Page
Loading...