Tool-free rapid quick change (see Fig. 2):
I: Cartridge quick change
II: Spring-loaded pressure piece
III, IV: Set-screw with soft washer
V: Chuck jaws
The chuck jaws can be mounted and removed manually without
any tools. Position the chuck jaws as in Fig. 1 and then slide into
the hook until the chuck jaws noticeably engage. The quick change
shown is only suitable for O.D. clampings.
The spring-loaded pressure piece (II) can be finely adjusted. To do
this, slightly loosen the set-screw (III) and adjust the spring-loaded
pressure piece. Then tighten the set-screw (III).
Figure 1
Figure 2
To Next Page
Loading...
