- 19 -
5.4 COPY
The COPY button offers you the opportunity to copy all parameters of a certain circuit or the
omplete time program and insert it into the program of one or many other control circuits.
ZONE, signal and number of Zone 2 start to blink. „COPY“
appears in the display to signalise the copy mode. Push
COPY to paste the data of Zone 2 (heating area 2). The
data of ZONE 1 are now copied into ZONE 2, The numeric
2 is signalling the completion of the copy process.
Now ZONE 3 is selected and starts to blink. Push COPY to
paste the data of ZONE 2 into ZONE 3.
The numeric 2 and 3 are signalling the completion of the
copy process.
Now push the SEL button to select a new zone.
In the next step ZONE 4 is selected (4 starts to blink).
Push the COPY button to paste the data into ZONE 4.
The display is signalling the completion of the copy
process. The data of ZONE 1 has now been pasted into
ZONE 2-3-4. To finish the copying of the parameters you
have to press DISP, while you have to use the PR-button
to finish the copying of time programs.
To copy parameters hold DISP
(approx. 3 sec., chapter 3.11).
Protected function!
To copy time programs use the PR button
(chapter. 2.2).
To exemplify the procedure, we try to copy data
of ZONE1.
To Next Page
Loading...
Need help?
General
