- 7 -
4.1.2 Selection of the control zone
4.1.3 Activation and deactivation of the shown control-zone
If you want to stop heating a certain zone push the button. The symbol will sign the
deactivation of the zone. In the deactivated zone only temperature measurement and display
are still working. You can activate the control zone again by pushing the button.
4.1.4 Special information in the base display
The display of the controller and its
usage is based on the display of the
control circuit. The control zone can
be chosen by pushing the ZONE
button. Now, all settings of the control
zones can be managed and
progressed.
During the optimised warm up time you will notice the OPT
symbol. The activation time of a specific zone is
accelerated in dependency of the preheating performance
compared to the entered heating time. This function can be
deactivated only in the setup-menu. An outside sensor
ATF is necessary.
While using the holiday-mode the
sign will be
marked.
To stop or modify the holiday program, please push
the
button (chap. 4.5).
Option: By pushing the override button the day mode starts
for a pre-programmed time (0:00-24:00h; standard 1h). At
the same time the +h symbol will be marked. The mode
can be stopped by using the
button.
To Next Page
Loading...
Need help?
General
