Schweitzer Engineering Laboratories SEL-2890 - Figure 1.2 SEL Default HTTP (WEB=SEL)

Date Code 20210715 SEL-2890 Instruction Manual
Introduction & Specifications
Applications
1.5
➢ nodelist.txt
➢ open.gif
➤ User (Folder)
➢ logo.jpg (maximum 16KB)
➢ nodelist.txt
First, familiarize yourself with the SEL default HTTP files in Figure 1.2. The callout
numbers located on the left side of the HTML code are referenced in Ta bl e C .1.
Figure 1.2 SEL Default HTTP (WEB=SEL)
Email
A Simple Mail Transfer Protocol (SMTP) email client is provided in the SEL-2890.
The primary purpose for the email function is to allow unsolicited messages, including
summary event reports, to be emailed. An unsolicited message is one that is sent to the
SEL-2890 when no Telnet or HTTP session is active. The SEL-2890 will take the
unsolicited data and email it to a designated email address. More than one unsolicited
message may be contained in an email. Also, an unsolicited message may be broken up
into more than one email. Email is sent two seconds after the end of an unsolicited
message. The end of an unsolicited message is determined by the MTDELAY setting.
The SEL-2890 will send an email message to the email server. If the email server is
unavailable the SEL-2890 will retry at a 1-minute, a 10-minute, and a 30-minute
interval. The message will be discarded if not successfully sent on the third try.