Schwinn 190 - Page 16

16
11. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Be sure to record the serial number in the field provided at the front of this manual.
Carefully remove the protective plastic film from the display screen, keypad and top of the Console. Due to static electricity,
“ghost” images may show on the screen but these will disappear after a few minutes.
!
Do not use or put the machine into service until the machine has been fully assembled and inspected for
correct performance in accordance with the Owner’s Manual.
NOTICE:$IWHU\RXU¿UVWIHZZRUNRXWV
some hardware will need to be
WLJKWHQHGDJDLQ7RHQVXUHTXLHW
and smooth operation, make sure
to tighten the indicated hardware
after three workouts. Consult the
Maintenance section of this manual
for recommended future service
intervals.
X2
X2
Pedals
Stabilizers
Stabilizer
Console Mast