Schwinn 190 - MAINTENANCE

30
Read all maintenance instructions fully before you start any repair work. In some conditions, an assistant is necessary to
do the necessary tasks.
!
Equipment must be regularly examined for damage and repairs. The owner is responsible to make sure that
regular maintenance is done. Worn, damaged or loose components must be repaired or replaced immedi-
ately. Only manufacturer supplied components can be used to maintain and repair the equipment.
If at any time the Warning labels become loose, unreadable or dislodged, replace the labels. If purchased
in US/Canada, contact Customer Service for replacement labels. If purchased outside US/Canada, contact
your local distributor for them.
Disconnect all power to the machine before you service it.
Daily: %HIRUHHDFKXVHH[DPLQHWKHH[HUFLVHPDFKLQHIRUORRVHEURNHQGDPDJHGRUZRUQSDUWV
'RQRWXVHLIIRXQGLQWKLVFRQGLWLRQ5HSDLURUUHSODFHDOOSDUWVDWWKH¿UVWVLJQRIZHDURU
damage. Check Pedals and tighten as needed. After each workout, use a damp cloth to wipe
your machine and Console free of moisture.
Note:$YRLGH[FHVVLYHPRLVWXUHRQWKH&RQVROH
NOTICE: If necessary, only use a mild dish soap with a soft cloth to clean the Console. Do not
clean with a petroleum based solvent, automotive cleaner, or any product that contains
ammonia. Do not clean the Console in direct sunlight or at high temperatures. Be sure
to keep the Console free of moisture.
Weekly: Check pedals and crank arms and tighten as necessary.
Do not back, or reverse, pedal. Doing so may loosen the Pedals, which could result
in damage to the machine and/or injury to the user. Never operate this machine with
loose Pedals
Clean the machine to remove any dust, dirt, or grime from the surfaces. Check for smooth
VHDWVOLGHURSHUDWLRQ,IQHHGHGDSSO\DYHU\WKLQFRDWLQJRIVLOLFRQHOXEULFDQWWRHDVH
operation.
Silicone lubricant is not intended for human consumption. Keep out of reach of
children. Store in a safe place.
Note: Do not use petroleum based products.
Monthly
or after 20 hours:
Make sure all bolts and screws are tight. Tighten as necessary.
MAINTENANCE