Schwinn 190 - Page 33

33
Condition/Problem Things to Check Solution
Check magnet position
UHTXLUHVVKURXGUHPRYDO
Magnet should be in place on pulley.
Check Speed Sensor
UHTXLUHVVKURXGUHPRYDO
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Resistance does not
change (machine turns on
and operates)
Check data cable integrity All wires in cable should be intact. If any are visibly pinched or
cut, replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly.
Reseat all connections. Small latch on connector should line up
and snap into place.
Check Servo Motor
UHTXLUHVVKURXGUHPRYDO
If magnets move, adjust until they are within the proper range.
Replace Servo Motor if not functioning properly.
Check Console Check for visual sign that Console is damaged. Replace Con-
sole if damaged.
If the above steps do not resolve the problem, contact Cus-
tomer Service (if inside US/Canada) or your local distributor (if
outside US/Canada) for further assistance.
&RQVROHVKXWVRႇHQWHUV
sleep mode) while in use
Check electrical (wall)
outlet
Make sure unit is plugged into a functioning wall outlet.
Check connection at front
of unit
Connection should be secure and undamaged. Replace
adapter or connection at unit if either are damaged.
Check data cable integrity All wires in the cable should be intact. If any are cut or pinched,
replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Reset machine Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Check magnet position
UHTXLUHVVKURXGUHPRYDO
Magnet should be in place on pulley.
Check Speed Sensor
UHTXLUHVVKURXGUHPRYDO
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Unit rocks/does not sit
level
Check leveler adjustment Adjust levelers until bike is level.
Check surface under unit $GMXVWPHQWPD\QRWEHDEOHWRFRPSHQVDWHIRUH[WUHPHO\XQ-
even surfaces. Move bike to level area.
3HGDOVORRVHXQLWGLႈFXOW
to pedal
Check pedal to crank arm
connection
Pedal should be tightened securely to crank. Insure connection
is not cross-threaded.
Clicking sound when
pedaling
Check pedal to crank arm
connection
Remove pedals. Make sure there is no debris on threads, and
reinstall the pedals.
Seat post movement Check locking pin Be sure adjustment pin is locked into one of the seat post
adjustment holes.
Check adjustment knob Be sure knob is securely tightened.
Console continuously
cycles through program
screens
Console is in demonstra-
tion mode
Press and hold the Schwinn
™
logo button for 3 seconds. The
VHWWLQJZLOOWDNHHႇHFWDIWHUWKHQH[WWLPHWKHPDFKLQHJRHVLQWR
Sleep Mode.