Scytek electronic A20 - Adding;Replacing 2-Way LCD Transmitters; Setting the Alarm Clock; LCD Backlight; System Confirmation

Page 4 - G777,G27,A777,A20
Power Save Mode
Power save mode disables automatic pager operations, alarm and starter status must be checked manually using button
5 for confirmation.
1. Press and hold Buttons 2 and 3 until the remote beeps six times.
· “PS” is shown indicating Power Save set/reset mode is entered.
2. Press Button 1 to toggle Power Save On/Off.
· The remote will display On or Off indicating the current status of the pager.
Pager power save mode status is indicated bellow
LCD Backlight
Transmitter Button 5 is used for confirmation, transmitter programming, as well as activation of the LCD
backlighting for use in the dark. Press and release button 5 momentarily to activate the LCD backlight.
System Confirmation
The 2-way transmitter's confirmation feature allows the current vehicle status to be displayed at any time.
To display system status:
1. Press and hold Button 5 until the display shows CON.
· The transmitter will beep once.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will display the current system status.
Programmable Functions using the LCD Transmitter
Pressing and holding transmitter button 5 will scroll through several transmitter programmable options -
DEG, AUTO, SPCL, SSCL, C St, H St, A St, Snd .
DEG Check the temperature inside the vehicle
1. Press and hold Button 5 until the display shows DEG
·The transmitter will beep twice.
2. Release Button 5.
· The transmitter will beep four times.
· The LCD panel will display the temperature inside the vehicle
Normal
Mode
Power Save
Mode