SE3D r3bEL mini - Page 16

r3bEL mini User Manual
16
If you are a previous 3D printer user and already have Slic3r installed on your computer, please
note the warning below:
Next, to load the “Lotion” config file (.ini file type) that you extracted previously. Follow steps
below for installation:
1. Go to File > Load Config…
2. Select the Lotion.ini file
and click Open.
WARNING
Do not use the default configuration settings in Slic3r. The default settings
will cause the extruder to heat to high temperatures and melt your syringe.
Ensure that you have loaded the “lotion.ini” config file prior to your first print.