r3bEL mini User Manual
17
3. You should now see that
your printer, filament and
print settings on the right
panel have all changed to
Lotion.ini instead of the
default settings.
4. Save the lotion settings in
each Slic3r tab so that it
becomes the default by
clicking the save button in
the upper left corner in
each of the settings tabs.
As a final check to ensure that your temperature settings on Slic3r is correct, click on the Filament
Settings Tab. Make sure you are looking at the lotion config file and check that your temperature
settings match the settings shown below:
To Next Page