SPECIAL PROCEDURES
AVAILABLE MODE FUNCTION
IBR-OVR MODE message
5. Press the SET button to enter IBR
OVR function and display OVR OFF.
MESSAGE DISPLAYED
OVR OFF
6. Press the UP/DOWN button (RH
handlebar) to display OVR ON.
MESSAGE DISPLAYED
OVR ON
7. Press the SET button to select the
OVR ON function. The gauge will
return to its normal display.
8. Press the VTS UP/DOWN arrow but-
tontomovetheiBRgatetothede-
sired position.
Models Without a VTS UP/DOWN
Button
NOTE: On models without the VTS
UP/DOWN button, use the UP/DOWN
button on the RH handlebar to move
the iBR to the desired position once
the iBR override function has been ac-
tivated as described in the previous
steps.
All Models
9. Remove the tether cord from the
engine cut-off switch.
WARNING
If it is necessary to reach in to re-
move any foreign object caught
in the propulsion system, strictly
observe the following before pro-
ceeding:
– Remove tether cord from the
engine cut-off switch.
– Waitatleast5minutes.
– Do not press on START/STOP
button. Should the START/
STOP button be pressed, wait
another 5 minutes.
Deactivating iBR Override Function
There are three ways to deactivate the
iBR override function:
– Repeat steps in
ACTIVATING iBR
OVERRIDE FUNCTION
and press
the SET button when OVR OFF is
visible.
– Wait for the electrical power to shut
off.
– Start the engine.
NOTE: When the engine is started,
the iBR OVR function is deactivated
and the iBR gate will move to the neu-
tral position.
______________
101
To Next Page
Loading...
Need help?
General
