OPERATING MODES
9. To launch the PWC in ski mode, pull
in and hold the throttle lever all the
way to the handlebar grip. The PWC
will accelerate to the set TARGET
SPEED and the SKI MODE indicator
will be on steady.
10. To increase or decrease the TAR-
GET SPEED during a ski run, press
the UP/DOWN button, do not re-
lease the throttle lever.
sdd2009-001-024_h
1. Hold throttle lever in
2. Press UP button to increase speed
3. Press DOWN button to decrease speed
NOTE: Ifthethrottleispartlyreleased
during a ski run, the SKI MODE indica-
tor light will start to blink and the speed
adjustfunction using the UP/DOWN ar-
row button will be deactivated.
11. To end aski run or to pick up a fallen
skier or wakeboarder, fully release
thethrottletoregainnormalthrot-
tle control.
NOTE: When the throttle is fully re-
leased during ski mode operation, the
system returns to ski mode engaged
status. The SKI MODE indicator light
will go out but, ski mode will remain
engaged and a message to that effect
will reappear in the multifunction dis-
play.
12. Press SET to reactivate ski mode
and fully pull in the throttle lever to
start another ski run.
Deactivating Ski Mode
To exit ski mode at any given point dur-
ing the ski mode setting process, press
the MODE button.
To end a ski run and completely deac-
tivate ski mode, release the throttle to
idle, then press the MODE button.
Learning Key and Rental
Key Modes
Both learning and rental keys provide
a mode of operation whereby engine
power and speed is limited.
There are 5 speed settings available for
the learning key mode. By default, the
key modes are preset to the speed set-
ting (3).
NOTE: Changing key settings is only
available when the engine is not run-
ning.
Changing Learning Key Speed
Settings
GTS Models
The default learning key setting is
74 km/h (46 MPH) and cannot be
changed on these models.
All Models Except GTS
To change learning or rental key set-
tings, carry out the following:
1. Press the START/STOP button to
wake up the electrical system and
install the NORMAL key on the en-
gine cut-off switch.
2. Wait for the information center to
complete its self-test and display
the key recognition message.
3. Press the MODE button repeatedly
until KEY MODE is visible in the digi-
tal screen of the information center.
_______________
97
To Next Page
Loading...
Need help?
General
