PRE-RIDE INSPECTION
WARNING
Perform a pre-ride inspection before each ride to detect potential problems
during operation. The pre-ride inspection can help you monitor wear and
deterioration before they become a problem. Correct any problems that
you discover to reduce the risk of a breakdown or crash. See an authorized
Sea-Doo dealer as necessary.
Before performing the pre-ride inspection, read and understand the
CONTROLS
section.
What to Do Before Launching the Watercraft
WARNING
Engine should be off and the tether cord cap should always be removed
from the engine cut-off switch prior to verifying any of the following points.
Only start watercraft once all items have been checked and operate prop-
erly.
Check the items listed in the following table before launching the watercraft.
ITEM OPERATION
✓
Hull Inspect.
Jet pump water intake Inspect/clean.
Drain plugs Tighten.
Fuel tank Refill.
Engine compartment
Check for any fluid leaks and gasoline
vapor odor.
Engine oil level
Check/refill.
Engine coolant level
Check/refill.
Steering system Check operation.
Throttle lever
Check operation.
iBR lever (except GTS models) Check operation.
Front storage compartment cover,
glove box and seat
Ensure they are closed and latched.
36
_______
SAFETY I
NFORMATION
________
To Next Page
Loading...
Need help?
General
