OPERATING INSTRUCTIONS
How to Engage Neutral
iBR Equipped Models Only
WARNING
The drive shaft and impeller are
always turning when the engine is
running, even in neutral position.
Keep away from the propulsion
system of the watercraft.
When the watercraft is first started,
the iBR system automatically sets the
neutral position by default.
To engage neutral from forward posi-
tion, tap the iBR lever.
To engage neutral from reverse posi-
tion, release the iBR lever and throttle
lever.
How to Trim the Neutral Position of
the iBR
When in NEUTRAL, if the watercraft
creeps forward or backward, the iBR
system may be trimmed.
NOTE: Movement of the watercraft
when operating in neutral may be due
to wind or water current.
If the watercraft is moving forwards,
momentarily press the DOWN button.
If the watercraft is moving backwards,
momentarily press the UP button.
sdd2009-001-024_i
TRIMMING THE iBR NEUTRAL POSITION
1. UP button (to stop rearward movement)
2. DOWN button (to stop forward movement)
NOTE: Press the UP/DOWN button
repeatedly until proper adjustment of
the neutral position is attained and the
watercraft stops moving.
How to Engage Forward
iBR Equipped Models Only
To engage forward from neutral po-
sition, tap on the throttle lever. The
watercraft will accelerate forward.
To engage forward from reverse posi-
tion, release the iBR lever, then tap the
throttle lever.
To re-engage forward from braking, si-
multaneously pull in the throttle lever
while releasing the iBR lever. The wa-
tercraft will accelerate forward after a
short delay.
smo2009-002-201_b
ENGAGING NEUTRAL
1. Throttle lever
How to Engage and Use
Reverse
iBR Equipped Models Only
Reverse can only be engaged between
idle speed and the threshold forward
speed of 8 km/h (5 MPH).
To engage reverse position, the iBR
lever on the LH handlebar must be
pulled in at least 25% of the lever
travel.
78
______________
To Next Page
Loading...
Need help?
General
