MONITORING SYSTEM
Beeper Code Information
BEEPER CODES DESCRIPTION
Bad D.E.S.S. system connection.
Reinstall tether cord correctly on engine cut-off switcht.
Wrong D.E.S.S. key.
Use a tether cord that has been programmed for the
watercraft.
Defective D.E.S.S. key.
Use another programmed tether cord.
Dried salt water in tether cord cap.
Clean tether cord cap to remove salt water.
Defective engine cut-off switch.
Refer to an authorized Sea-Doo dealer.
1 long beep
(when installing tether
cord on engine cut-off
switch)
Improper operation of ECM or defective wiring
harness.
Refer to an authorized Sea-Doo dealer.
Watercraft is upside down.
Turn watercraft upright. Refer to
SPECIAL PROCEDURES
.
A 2 second beep
every 15 minute interval
Engine management system fault.
Refer to an authorized Sea-Doo dealer.
Low fuel level.
Refill fuel tank. If problem persists, refer to an authorized
Sea-Doo dealer.
A 2 second beep
every 5 minute interval
Fuel tank level sensor or circuit malfunction.
Refer to an authorized Sea-Doo dealer.
High engine coolant temperature.
See
ENGINE OVERHEATING
.
High exhaust temperature.
Refer to an authorized Sea-Doo dealer.
Continuously beeps
Low oil pressure.
Turn off engine as soon as possible. Check oil level and
refill. Refer to an authorized Sea-Doo dealer.
NOTICE
If the monitoring beeper continuously sounds, stop engine as
soon as possible.
______________
145