PRE-RIDE INSPECTION
ITEM OPERATION
✓
Wakeboard rack (WAKE model)
– Ensure rack is properly installed and
secured.
– Make sure bungee cords are in good
condition.
– Ensure wakeboard is correctly installed
in rack and secured.
Ski/wakeboard post (WAKE model)
Inspect and check operation.
Engine cut-off switch and engine
START/STOP button
Check operation.
Hull
Inspect hull for cracks and other dam-
ages.
Jet Pump Water Intake
Remove weeds, shells, debris or any-
thing else that could restrict the flow of
water and damage the propulsion unit.
Clean as necessary. If any obstruction
cannot be removed, refer to an autho-
rized Sea-Doo dealer for servicing.
F18J04Y
21
TYPICAL — INSPECT THESE AREAS
1. Water intake
2. Ride plate
Drain Plugs
Secure bilge drain plugs.
smo2009-002-135_a
TYPICAL - BILGE DRAIN PLUG LOCATIONS
1. Bilge drain plugs
2. Tighten
3. Untighten
WARNING
Ensure bilge drain plugs are prop-
erly secured prior to launching the
watercraft in water.
Fuel Tank
Fill the fuel tank.
WARNING
Strictly adhere to instructions de-
tailed in
FUELING PROCEDURE
.
Engine Compartment
Inspect the engine compartment for
fuel vapor odor.
________
SAFETY INF
ORMATION
________
37
To Next Page
Loading...
Need help?
General
