CONTROLS
smo2009-002-115_a
TYPICAL
1. Tether cord cap on the engine cut-off switch
2. Tether cord clip secured to operator's PFD
To stop engine, pull the tether cord cap
from the engine cut-off switch.
WARNING
Should the engine be stopped, the
brake function (models with iBR)
and watercraft directional control
is lost.
WARNING
Always disconnect the tether cord
when the watercraft is not in oper-
ation in order to preventaccidental
engine starting or to avoid unau-
thorized use by others, children,
and to prevent theft.
Digitally Encoded Security System
(D.E.S.S.)
The tether cord cap contains a D.E.S.S.
keythatisprogrammedtogiveita
unique electronic serial number. This
is the equivalent of a conventional key.
The D.E.S.S. system reads the key
in the tether cord cap that is installed
on the engine cut-off switch, and only
allows engine starting for keys it rec-
ognizes.
The D.E.S.S. system brings great flex-
ibility. You can buy additional tether
cords and have the D.E.S.S. keys pro-
grammed to your watercraft.
A total of ten D.E.S.S. keys can be pro-
grammed to the same watercraft.
To have a key programmed to your
watercraft, see your authorized BRP
Sea-Doo dealer.
D.E.S.S. Key Recognition
Two short beeps indicate the system
is ready to allow engine starting. Oth-
erwise, refer to the
TROUBLESHOOT-
ING
section.
D.E.S.S. Key Types
Three types of keys can be used:
–Normalkey
– Learning key
– Rental key (rental models).
To ease key type recognition, the
tether cord float comes in different
colors.
KEY TYPE FLOAT COLOR
Normal Yellow or Black
Learning
Green
Rental
Orange
sdd2009-001-025
TYPICAL - D.E.S.S. KEYS (TETHER CORDS)
1. Learning key, green float
2. Rental key, orange float
The information center displays the
type of key used.
46
______________
To Next Page
Loading...
Need help?
General
