FUNCTION MENUS
44
UP
UP
DN
DN
CHANGING THE SSB AGC CHARACTERISTICS
The SSB AGC controls the radio’s receiver gain when receiving non TELEX
mode signals. The characteristics may be changed to one of two settings labeled
“FAST” and “SLOW”. The “FAST” setting uses feedforward AGC.
Feedforward AGC is an aggressive AGC system that is very noise immune and
keeps the audio level fairly constant for received signals of different strength.
When “SLOW” is selected, the feedforward AGC is disabled and the receiver
will sound more like a conventional SSB receiver.
Repeatedly press until “SETUP” is
displayed.
Pressing with “SETUP” displayed
will prompt the operator to “PRESS+-”.
Press the or key until “SSB AGC” is
displayed then press
Each press of the or key will change
the SSB AGC characteristics. Press
to select the displayed setting.
Use a setting of “FAST” (default) for better
signal to noise ratio on weaker signals.
Use a setting of “SLOW” for a more
conventional sounding SSB receiver.
When “EXIT” is selected, the setting will not
be changed.
ENT
FNC
ENT
ENT
To Next Page