| Page 39 | SEABOB Operation Manual | 5
For this reason, you should follow the instructions
given in Chapter 5.12 "Storing the SEABOB and ac-
cumulator box ACS" and Chapter 5.13 "Air trans-
port / transport of the SEABOB and accumulator
box ACS" on correctly switching off the device to
Off mode for air transport and storage.
Note: If the accumulator charge state is too high prior
to starting the partial charging process for air transport /
transport, you will have to perform a discharge by run
-
ning the accumulator box to empty in a controlled fash
-
ion as described in Chapter 5.13.
Switching on from Off mode:
When the system is in Off mode, it can only be switched
back on by initiating the charging process.
1. Plug the charging plug into the charging socket on
the accumulator box.
2. Plug the mains plug into the mains socket.
3. Activation of the SEABOB is triggered by the inde
-
pendent electronic control system in the accumulator
box together with a correctly detected charger (sys
-
tem check).
4. The charge display will appear in the display after 15
seconds. The SEABOB is now in Charge mode.
5. Decide how to proceed using the green or red but
-
ton (see Chapter 5.4.9 "Charge mode" and Chapter
5.4.10 "Charge display").
5.4.6 Sleep mode – switching on / off
In Sleep mode, the display and motor are switched off.
Switching on from Sleep mode:
Note: If the Powergrip is not activated within 3 seconds
after tapping the blue button during activation, the dis
-
play will switch off again (device reverts to Sleep mode).
1. Tap the blue button.
2. The display is switched on, and the SEABOB logo ap
-
pears.
3. Pull the Powergrip against the Controlgrip (within
3 seconds). Hold it there until the software version
number under the SEABOB logo in the display disap
-
pears after 1 second (this step is for calibration of the
on / off position of the Powergrip; Teach-in).
4. Release the Powergrip completely.
5. The User-PIN or Owner-PIN prompt will appear in the
display (if activated). If the PIN prompt has been de
-
activated, the operation display will appear directly.
6. The display illumination will switch off (Stand-by
mode) if the user does not activate a button or the
Powergrip within 1 minute.
Note: The PIN prompt when switching on the device
can be activated using the optional software available
on CD.
Automatic switching off to Sleep mode (Time-off):
If the user does not activate one of the four buttons
or the Powergrip within 1 minute, the system will
first switch to Stand-by mode (display illumination is
switched off). If no actions are performed by the user
within the next 10 minutes (Time-off), the SEABOB logo
will appear. After another 15 seconds, the system will
switch off automatically to Sleep mode.
To Next Page
Loading...
