| Page 41 | SEABOB Operation Manual | 5
5.4.8 On mode
The display illumination is switched on. The motor is
switched on by pulling the Powergrip (the motor runs
with a minimum power of 10 %). If the user does not
activate a button or the Powergrip within 1 minute, the
system first switches to Stand-by mode. After another
10 minutes have elapsed without any action by the user
(Time-off), the system reverts automatically to Sleep
mode.
5.4.9 Charge mode
The charger is connected to the device and is supplying
the charging voltage. Before charging begins, an ac
-
cumulator / charge diagnostic check (system check) is
performed. Charging is activated once the diagnostic
check has been completed successfully. It is not possible
to switch on the motor. After 15 seconds, the charge dis
-
play showing the accumulator symbol will appear in the
display (see Chapter 5.4.10 "Charge display").
The system can only be switched from another mode to
Charge mode using a connected and active charger.
Note: If the charger is disconnected from the device,
thereby interrupting the charging voltage, the SEABOB
switches off after 1 minute (system check) and switches
to Off mode (if programmed to partial charging) or to
Sleep mode (if programmed to full charging).
To Next Page
Loading...
