| Page 54 | SEABOB Operation Manual |
5
5.10 Switching off the SEABOB to Sleep
mode
Manual switching off to Sleep mode:
1. The operation display is shown in the display.
2. Tap the button combination silver*– blue in quick se
-
quence. The SEABOB logo will appear in the display.
3. Wait 15 seconds. If the user does not activate a but
-
ton or the Powergrip within this time, the SEABOB
will automatically switch off to Sleep mode.
Automatic switch-off (Time-off):
If the user does not activate a button or the Powergrip
within 1 minute, the SEABOB switches off the display il
-
lumination (Stand-by mode) after the time has elapsed
(Time-off). As soon as the user performs an action, the
display illumination switches back on, and the SEABOB
is ready for operation.
After 10 minutes have elapsed without any action by the
user (Time-off), the SEABOB logo appears on the display.
After another 15 seconds, the SEABOB switches off auto
-
matically to Sleep mode.
To switch the device back on from Sleep mode, see Chap
-
ter 5.4.6 "Sleep mode".
Note
: When the accumulator box is completely dis-
charged / run to empty, the SEABOB and the display
switch off completely (Off mode). The SEABOB can only
be switched on from Off mode using a connected and
active charger.
Charge the accumulator box immediately (within
24 hours) to at least the charge state "air trans
-
port / storage" to avoid irreparable total discharge of the
valuable Li-Ion accumulator cells.
5.11 Detaching the accumulator box ACS
(Accumulator Change System)
See also Chapter 5.3 "Installing the accumulator box
ACS".
Note: The following description applies only to
the SEABOB CAYAGO VX2 and SEABOB CAYAGO F7
models with Accumulator Change System (ACS).
These are the only models on which the accumula-
tor box ACS can be detached from the SEABOB and
changed.
1. Place the SEABOB ACS and accumulator box ACS on a
dry and sturdy surface that will not damage the com
-
ponents.
2. Fold the grips of the quick clamps upward, and turn
them anticlockwise until they are fully open.
3. Pull the quick clamps applied to the accumulator box
away from the accumulator box.
4. Turn the grips of the quick clamps clockwise again to
shorten the length of the quick clamps.
5. Fold the quick clamps back down so that they lie flat
against the accumulator box. The quick clamps should
be positioned so that they are flush with the locking
hooks.
* or black
Grip Locking hookQuick clamp
To Next Page
Loading...
