| Page 40 | SEABOB Operation Manual |
5
Manual switching off to Sleep mode:
You can also switch the SEABOB to Sleep mode manually.
To do so, proceed as follows:
1. The operation display is shown in the display.
2. Tap the button combination silver*– blue in quick se
-
quence. The SEABOB logo will appear in the display.
3. If the user does not activate a button or the Powergrip
within 15 seconds, the system will switch to Sleep
mode and switch off.
5.4.7 Stand-by mode
In this mode, the display and control panel are active and
ready for a command from the user. The display illumina
-
tion is switched off. No current is flowing to the motor.
If the user activates a button or the Powergrip, the system
switches to On mode and the display illumination switch
-
es on. If the user does not perform any actions within
1 minute, the display illumination switches off again (de
-
vice reverts to Stand-by mode). After another 10 minutes
have elapsed without any action by the user (Time-off),
the system reverts automatically to Sleep mode.
* or black
To Next Page
Loading...
