Seaga N2G5000 - Beep Enable

EL950.1.1.1062C.4-2017
Page45
6. Press9toreturntoStSMenu
StS‐‐‐:
*
‐Exit
7. EnterSelection(inourexample,140)
StSXXX:(inourexample,401)
*
‐Exit,nochange#toSave
1toClear?
8. Press1toclearlinksmenu
XXX:Clearlinks?
*
‐Exit,nochange#toClear?
9. Press#toclearcurrentlinkssettings
XXX:Cleared
*
‐Exit,nochange#Add
1–Clear
10. Press#toaddnewselection
XXX:‐‐‐
*
‐Exit,nochange
11. Enternextselection 
XXX:YYY (inourexample,140)
*
‐Exit,nochange#Add
12.
Press#toaddanotherselection(toentermoreselections,
repeatsteps10and11)
XXX:YYY,ZZZ
(Inourexample,141)The
displayshowstheselections
youhaveentered.After3
selections,thescreenwill
scrollallthelinksyouhave
made.
13.
Press
*
twotimestoexit
0.00
AD
VANCEDCONFIG*
Apasswordisrequiredtoenterthismenu.Thefactorydefaultpasswordis2314.Thefollowing
menusareavailableunderthissub‐menu:
 BeepEnable

Temp
 OpticsDisables

SelectionStyle
 MotorType
BEEPENABLE
STEP DISPLAY
1. PressServiceModeButton MotorCountorErrorCode**
2. Press4forConfiguration Configuration
3. Press0forAdvancedConfig
Password:
Usekeypadtoenterpassword
4. Press1forBeepEnablemenu
BeepEnable(CurrentSetting)
*
‐Exit,nochange1‐Edit
5. Press1totoggleON/OFF
BeepEnable(ChoiceFlashing)
*
‐Exit,nochange#toSave
6. Press#tosavethesetting
BeepEnable(NewSetting)
*
‐Exit,nochange1‐Edit
7.
Press
*
threetimestoexit
0.00
For more information contact: Gumball.com (800) 260-0010 support@gumball.com