Seaga N2G5000 - Equipment Setup; Loading Snack Trays; Products

EL950.1.1.1062C.4-2017
Page9
EquipmentSetup
LoadingSnackTrays
Eachsnack trayhasareleaseleverlocatedonth erightside.Toplacethetrayinloadposition,
holddownonthe releaseleverandliftthetrayupslightly;slidethetrayforward(towardyou)
untiltherollerhitsthestopbuiltintothesiderail.Gentlylowerthefrontofthesnacktrayuntil
itistilteddownandallcoilsareexposed(Figure5).
Figure5–SnackTrayinLoadPosition
When loaded,liftthetrayfrontupsothatthetrayislevelandpushback intoposition.NOTE:
Make sure the wheels on thefront of thetr
ay are engaged properly in the side  rails and the 
releaseleverisintheforwardposition.
Products
Makesureyourproductsareappropriateforthecolumnandcoilyouareplacingthemin.Donot 
force products that are too  wide  into a narrow tray or too tight coil as  this will cause vend
problemsforyourcustomers.Theproductmustalsopassunderthetrayimmediatelyabovethe
oneyouareloadingandshouldnottouchproductsoneitherside.
Once you have the appropriately sized products for each selection, correct loading of the
productsshouldbebetweenthecoilsandrestingontheproducttrayitself.SeeFigures6and6a:
Eachtrayhasa
ReleaseLever
TrayinLoadPositio n
IMPORTANT:
Makesurefront
wheels onboth
sidesareproperly
engagedinside
railswhenplacing
traybackinsales
position.
For more information contact: Gumball.com (800) 260-0010 support@gumball.com