Seaga N2G5000 - EXACT CHANGE; ALTERNATE RULE

EL950.1.1.1062C.4-2017
Page56
29. Press9forEnableDiscountmenu
Enable(ChoiceFlashing)
*
‐Exit9‐Edit
30. Press9totoggleEnableON/OFF
Enable(ChoiceFlashing)
*
‐Exit#‐Save
31. Press#tosavethesetting
Enable(NewSetting)
*
‐Exit9‐Edit
32.
Press
*
fivetimestoexittoSalesMode
0.00
EXAC
TCHANGE
SetsthecointubevaluethatwilltriggerthedisplaytoshowPleaseUseExactChangemessage.
Forexample,ifExactChangeissetto$5.00,themessagewilldisplaywhenthetotalofcoinsin
thetube,ascountedbytheVMC,isatorbelow$5.00total.
ST
EP DISP
LAY
1. PressServiceModeButton MotorCountorErrorCode**
2. Press6forPassword(AdvancedFeatures)Menu Password
3. EnterPassword(default2314) AdvancedFeatures
4. Press2forExactChange
ExactChange$‐‐.00
*
‐Exit1‐Edit
5. Press1toeditExactChange
ExactChange(Flashing)
*
‐Exit1‐Edit
6. Usenumberkeystoenteranamount
ExactChange(NewSetting)
*
‐Exit1‐Edit
7. Press#tosavethesetting
ExactChange(NewSetting)
*
‐Exit#‐Save
8.
Press
*
twotimestoexit
0.00
ALTE
RNATERULE–Thisfunctionpreventsavendfromoccurring,flashesthePleaseUseExact
Changemessageandwillreturntheestablishedcreditamountifoneormoreofthecointubes
aretoolowtogivebackthecorrectchangeforthevend.
Note: This setting must be OFF if using
a bill validator only. If using a bill validator only, prices must be divisible by the denominations
accepted by the bill validator.

STEP DISPLAY
1. PressServiceModeButton MotorCountorErrorCode**
2. Press6forPassword(AdvancedFeatures)Menu Password
3. EnterPassword(default2314) AdvancedFeatures
4. Press2forExactChange
ExactChange$‐‐.00
*
‐Exit1‐Edit
5. Press2tosetAltRules
AltRules(CurrentSetting)
*
‐Exit2‐Edit
6. Press2totoggleON/OFF
AltRules(ChoiceFlashing)
*
‐Exit#‐Save
7. Press#tosavethesetting
AltRules(NewSetting)
*
‐Exit3‐Edit
8.
Press
*
twotimestoexit
0.00
For more information contact: Gumball.com (800) 260-0010 support@gumball.com