Seaga N2G5000 - Beverage Vending; My beverages arent vending at all.; My beverages are vending more than one at a time.; Power

EL950.1.1.1062C.4-2017
Page75
BeverageVending
Mybeveragesaren’tvendingatall.
1. Makesureallitemsareloadedcorrectly.
2. Makesureallproductloadedisinstalledinthecorrectselection.Loadproduct
accordingtothemachinePlan‐O‐Gram.AchangefromthePlan‐O‐Grammayrequire
newsetup.SeetheLoadingBeverageLanessectionofthismanualandstudythe
ProductGroupsandhowtoloadthemandaccessoriesrequired(ifany).
3. MakesuretheSensitivityAdjust(Menu>5Options>9SensitivityAdjust,see
Programmingsection ofthismanual)issetproperly.Ifthesensitivityissettoohigh,
thesensormaytrip beforetheproductdropsandstopthevendprocess
prematurely.Underadvisementfromtechnicalsupport,changethesensitivityfrom
hightomediumormediumtolowandtestvend.
Mybeveragesarevendingmorethanoneatatime.
1. Makesureallitemsareloadedcorrectly.ReviewLoadingBeverageLanessectionof
thismanualandverifyallrecommendationsandstepsarefollowedforyourtypeof
packaging.
2. MakesuretheDropSensorSensitivity(Menu>5Options>9Dro pSensor,see
Programmingsection ofthismanual)issetproperly.Ifthesensitivityissettoolow,
thesensormaynottripwhen theproductdropsandperformasecondvend.Under
advisementfromtechnicalsupport,changethesensitivityfrommediumtohighor
lowtomediumandtestvend.
TheselectionvendsfineinTestMode,butduringSalesModesaysMakeAlternateSelection.
1. Youhaveanerrorcodeorajamblockingtheuseofthatparticularselection.Youwill
needtoemptyallproductsandmakesuretherearenojams.Returntheaugerto
thehomepositionandreloadtheproduct.Thengotothemenuandclearthe
errors.Thiswillallowyoutore
sumevendingfromthatparticularselection(s).
Power
Icanseeandhearthecoolingdeckfans,butthereisnopowertotherestofthemachine.What
doesthismean?
1. Checkthetransformeronthefloorofthemachine.Thereisacoverthatgoesover
thetransformerwithaccesstothesmallbreakerswitchontopofthetra
nsformer.
Pressthebreakerswitchtoresetthetransformer.Thisshouldcausethemachineto
powerbackup.
2. Checktomakesurethatthemainpowerharnessthatrunsfromthetransformerto
theVMC.Makesureallconnectionsaregood.
For more information contact: Gumball.com (800) 260-0010 support@gumball.com