42 Hawk 2XL Product Manual, Rev. B
9.3 SCSI interface commands supported
Table 6 lists the SCSI interface commands that are supported in the SCSI-2 and SCSI-3 modes of the drive.
OEM standard drives are shipped set to operate in SCSI-2/SCSI-3 mode.
Table 6: Commands supported by Hawk 2XL family drive
Command
Code
Supported by:
SCSI-2/3 Command Name
00h Y Test unit ready
01h Y Rezero unit
03h Y Request sense
Y Extended sense
Y Field pointer bytes
Y Actual retry count bytes
Y Deferred error supported
04h Y Format unit [1]
N Block format
Y Bytes from index format
Y Physical sector format
N DPRY bit supported
07h Y Reassign blocks
08h Y Read
0Ah Y Write
0Bh Y Seek
12h Y Inquiry
Y Vital product data page
Y Unit serial number page
Y Implemented operating definition page
Y Firmware numbers page
Y Date code page
Y Jumper settings page
Y Device Behavior page
15h Y [2] [3] Mode select (same pages as mode Sense command, see below)
16h Y Reserve
Y 3rd party reserve
N Extent reservation
17h Y Release
18h N Copy
1Ah Y [2] [3] Mode sense
Y Boot page (00h)
Y Error recovery page (01h)
Y Disconnect/reconnect (02h) (DTDC, DIMM not used)
Y Format page (03h)
Y Rigid disc drive geometry page (04)
Y Verify error recovery page (07h)
Y Caching parameters page (08h)
N IC bit controllable
Y Control mode page (0Ah)
N Notch and Partition Page (0C)
N Power condition page (1A)
1Bh Y Start unit/stop unit (spindle ceases rotating)
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
To Next Page
Loading...