25
C/A glue..
3) When you are sure that everything
is aligned correctly, mix up a gener-
ous amount of Flash 30 Minute Epoxy.
Apply a thin layer to the mounting slot
and to bottom of the vertical stabilizer
mounting area. Apply epoxy to the bot-
tom and top edges of the ller block and
to the lower hinge also. Set the stabilizer
in place and realign. Double check all of
your measurements once more before the
epoxy cures. Hold the stabilizer in place
with T-pins or masking tape and remove
any excess epoxy using a paper towel and
rubbing alcohol. Allow the epoxy to fully
cure before proceeding.
MOUNTING THE TAIL WHEEL.
Locate items necessary to install tail wheel.
3x15mm
To Next Page
Loading...
